Categories

MARSHALL EXCELSIOR COMPANY MEC HIGH PRESSURE ADJUSTABLE REGULATOR WITH WRENCH, 1/2 IN. FNPT, 0-30 PSI, PRESET TO 15 PSI*

Vendor :

(No reviews yet) Write a Review
$0.00
SKU:
136419
short description:
1/2FNPT HP.ADJ.REG.W/WRENCH"
Item Number:
MEGR-164SR/22
The MEGR-164 Series adjustable high-pressure regulators offer a wide selection of available pressure ranges. High pressure regulators are typically used to reduce tank pressure to an intermediate pressure for use by another regulator. They may be used as high pressure regulators on distribution systems when used in conjunction with first-stage down stream regulators. When equipped with an integral relief valve (MEGR-164SR Series), the regulator may be used as a final-stage regulator on high pressure systems. It may also be used as a first-stage regulator when set at 10 PSIG (0,69 bar) or less. The 1/4-in. FNPT tapped side outlet can be used to install a pressure gauge or a hydrostatic relief valve. This series contains brass materials thatare not compatible with anhydrous ammonia service.|Adjustable/PSI Type|250 PSI Max. Inlet Pressure|1/2 FNPT or 3/4 FNPT Inlet Connection|1/2 FNPT or 3/4 FNPT Outlet Connection|Gray Urethane Exterior Finish|Steel Regulator Spring|Stainless Steel Stem Guide/Disk Holder|Fabric Reinforced Nitrile (NBR) Diaphragm|Cast Aluminum Bonnet / Body Material|Non-Relieving Vent
short description:
1/2FNPT HP.ADJ.REG.W/WRENCH"