Tectite 3/4 in. Push-to-Connect x 3/4 in. Female Pipe Thread x 18 in. Corrugated Stainless Steel Water Heater Connector

The 3/4 in. x 18 in. Tectite by Apollo Corrugated Stainless Steel Water Heater Connector was designed for the fast and simple installation of hot and cold water lines to water heaters. After applying pipe thread tape to the MNPT nipples on your water heater, thread the FNPT end of the Water Heater connector onto the tank and tighten with pliers. Then simply push the Tectite by Apollo Push-To-Connect end onto Copper, PEX, or CPVC pipes and your water heater is connected. Using Tectite by Apollo Corrugated Stainless Steel Water Heater Connectors is the fastest, cleanest, and simplest way to install a water heater.|No-kink corrugated stainless steel construction guarantees maximum flow rate even in tight radius bends|Constructed of lead free dezincification resistant (DZR) brass for superior reliability|Push-to-connect joints require no heat, solder, solvents or tools|Push-to-connect design allows for a simple and fast installation on any combination of copper, PEX, CPVC or PE-RT pipe|Fittings can be rotated after being installed for ease of use in tight spaces|Ideal for potable water and hydronic heating applications|Listed by IAPMO and listed to ASSE 1061/NSF 68|Meets UPC, IPC, and cUPC standard requirements|Demount clip allows for connector removal (sold separately)|Corrosion resistant for greater longevity|Maximum working pressure of 200 psi and maximum temperature of 250 degree F