ROBERTS 1 Gal. Indoor/Outdoor Carpet and Artificial Turf Adhesive

ROBERTS 6700 adhesive was designed for exterior or interior carpet installation and is a solvent-free for reduced health risks, a lower environmental footprint and high initial grab. This non-flammable adhesive may be used in areas where flammable adhesives pose a health risk due to fumes or flashback fires. Use this adhesive to adhere most indoor/outdoor carpets with polypropylene, rubber-backed (foam, marine, waffle), urethane and tufted, woven or non-woven/needle-bond backings.|For adhering most indoor/outdoor carpets and is ideal for decks, sunrooms and basements|Bonds with concrete, APA rated marine grade plywood, aged asphalt paving (hot applied), fiberglass and aluminum when surface is clean and roughened to promote bonding|Suitable for indoor and outdoor use|Moisture Control Adhesive - up to 5 lbs. MVER and 80% RH|Up to 30 minutes open time, 60 minutes working time and 24 to 48 hours curing time|Approximately 65 to 75, 90 to 110 and 100 to 120 sq. ft. per gallon coverage for smooth, polypropylene/woven, and non-woven/rough-backed carpet installations respectively|Suggested for use with a 1/8 in. x 1/8 in. x 1/8 in. U-notch trowel, 1/8 in. x 1/8 in. x 1/16 in. V-notch trowel, or 3/32 in. x 3/32 in. x 3/32 in. V-notch trowel depending on carpet installation type|Enviro-friendly, solvent-free and LEED compliant; VOC 1 g/L, SCAQMD Rule 1168|Protected by GoldGuard, an antimicrobial protection system that inhibits the growth of mold, mildew and odor causing bacteria in both wet and dry adhesives|CRI Green Label Plus Certified - GLP no. 36471|Non-flammable for safe use|10 year direct bond limited warranty|Recommended for covered exterior applications|May be used for artificial turf if the turf manufacturer suggests a latex based, full spread adhesive application